Caution...Try this at your own risk!!
In the real world and after hundreds of government regulations, you can’t get a good hamburger at any restaurant or any place that is regulated by a local Board of Health. It’s not gonna have any flavor because the fat content is regulated. It’s not gonna be cooked right in that it must be cooked to 165 or above finish degrees. You know... a dried out piece of leather.
Some history and you older folks might appreciate this. Years ago and when McDonalds first started, they had a plain burger that would just flat melt in your mouth. It was cooked to about 130 degrees and was pink in the middle and was just an outstanding treat. Well, that was axed and what they serve now is trash compared to the older burger. They also flat out had the best French fries in the world. Well, wouldn’t you know..the dogooders found out that they were cooking the fries in beef tallow. OMG, isn’t beef tallow just plain beef lard? As above, this was axed too and the best French fries you will ever taste is gone. Doncha love “Big Brother?”
Next, you can’t purchase good meat...again regulated by the darn government! I think floor scrapings are ok but the real secret to a great burger is the nice white beef fat and lots of it. And of course, it must be cooked to no higher than about 130 degrees for the best results. The over the counter USDA burger is just plain nasty and is so full of crap that it must be cooked to a much higher temp to kill off all the nasties in the meat.
Now, whatsa fellow to do??? MAKE YOUR OWN. Making your own is easy and you can control just what goes into the meat. It is much safer and I feel it is as safe as steak and can be cooked to the lower temps that will produce a much more flavorful burger.
My setup for making my own burger meat.
I started with two nice fresh cut chuck roasts that weighed a total of 7-1/2 pounds. Now for you folks that don’t know, ground chuck roast is about 80% lean and 20% fat. Much, much too lean for good burger. In the white bowl, I have about 5 pounds of good clean white fat cuttings from a whole ribeye loin and a couple of briskets. I would guesstimate this at about 75% fat and 25% lean.
The goal I am shooting for is about 60% lean and 40% fat in my completed burger.
Some might ask why I call it white burger? White is THE flavor in your burger! Just look at that beautiful stuff coming out of my grinder.
That is about 12 pounds of the most flavorful burger you will ever taste.
I bag this burger and then mark it for only my grilled burger meat as I sure don’t want to waste it in chili or some other treat.
I haven’t had a chance to cook any of this batch yet but here is three burgers from an earlier batch of my homemade burger.
These homemade burgers were cooked to about 130 internal degrees and this is the results. You bite into one of these and the juice goes down both sides of your chin and you know you are in Heaven.
Some of the above are my opinions and I don’t expect everyone to agree with me but I do eat some great burgers!
No comments:
Post a Comment