Monday, January 18, 2010

Pit Beef/Roast Beef on the Weber Kettle

Wife wanted some roast or pit beef and I was looking to do a rotisserie cook of some type so this cook just went together like peaches and cream. I decided to do it on my EZ-Que in the old stand by Weber Kettle which always gives me great results. Never had a bad cook with this setup.



I started out with two beef bottom round roasts from Sam's Club with one weighing in at 3.58 pounds and the other a little larger at 4.11 pounds. I like the smaller roasts as it gives me more of that great outside crust after cooking. This meat should make for some wonderful sandwiches!



I cut the hard fat off of the fat side and then sprinkled on a generous dose of garlic salt and black pepper.



I got the cooker out of the garage and loaded up the charcoal chimney with enough Rancher brickettes to fill the two charcoal baskets in the Weber kettle. I then lit up the chimney full of charcoal. Was a cool morning at about freezing and with some misting rain and fog in the area. As you can see, we still have some snow on the ground.



I got my 6" EZ-Que rotisserie basket out and loaded up the two rubbed bottom round roasts and got them ready for the cooker.

Went back outside and poured the charcoal into the baskets inside the cooker and added the drip pan with a little water and got the cooker ready to load for an indirect hight temp cook.



I loaded the meat into the kettle for this short cook.



With the freezing rain I decided to use my tailgater battery operated rotisserie spit motor for this cook and I replaced the D batteries and installed it and it worked well.

I wanted to cook this meat as hot as the cooker would get and I opened up all the vents and had a lid temp of around 425-475f degrees which should get these roasts done to medium rare in about an hour. Then the wife told me she didn't want them "moo-ing" so I decided to cook them a little longer.



I ended up cooking the roasts for about 75 minutes which gave me an internal temp of about 155-160f which is about medium done. It sure looked good and should make for some great beef.

Brought the meat inside the house and removed it from the EZ-Que basket.



The smell was wonderful and I couldn't wait to get some sliced up. Wrapped them in foil and let them cool some before I put them thru the slicer.



The meat coming off of the slicer.



It sure makes up a nice plate of thin sliced roast beef. Me and my lady fought over each of the last 1/4" thick crust pieces off of each block of meat that went thru the slicer as the slicer won't cut the meat all the way to your fingers! ouch! These thin crunchy chunks are to die for!!

Take a fresh onion bun, cut it in half, wrap it with a wet paper towel and place it into the nuker for a few short seconds to get it steamed and warmed up. Place a big pile of this roast beef on one side of the bun. Add a couple of slices of Swiss cheese on top of the meat, back into the nuker for a few seconds to melt the cheese. Add a big dollop of horsey sauce to the top of the meat and add the top of the bun for one great sandwich.

We did freeze the remainder of the meat in pound packets for future use.

2 comments:

  1. That pit beef looks perfect. I can taste the horseradish just from thinking about those pictures. Excellent job.

    ReplyDelete
  2. This comment has been removed by a blog administrator.

    ReplyDelete